This is an ideal solution for broadband access providers who wish to get full control over its coax networks (e.g. EOC) running in MDU subscriber’s building. HomeCNA is also commonly known as EOC (Ethernet over Coax). Broadband access providers can easily reach individual household and start their service offer (and get payment) without door-to-door service or even involve drilling hole and running cable.
By adding NMS adaptor, service providers will be able to monitor the whole network (down to each end point); making configuration change, set bandwidth available to each end point and maximum connected host number based on their payment plan, turn on/off end point when service was terminated. Network management can be performed on http web browser.
Specification
Processor
Intel IXP425 series
RAM
32MB
Flash memory
16MB
Flash memory
LAN ports
:
Four (4) 10/100 Mbps auto-sensing, Auto Uplink™ RJ-45 ports
WAN ports
:
One (1) 10/100 Mbps Ethernet RJ-45 port to connect to any broadband modem, such as EPON
LED Power (Green)
On: Power on
Off: Power off
Ethernet Link/Act (Green)
On: Link detected
Flashing: Data Tx/Rx in process
Off: No link detected
Power adapter
Input
:
linear 100~120VAC or 200~240VAC
Output
:
12V/1.2A
Power consumption
Under 10W
Dimension
25.4 x 17.8 x 3.96 cm
MTBF
2 years
Network standard
IEEE 802.3
IEEE 802.3u
IEEE 802.3x
Bandwidth control
Upstream Bandwidth Management per client
Dynamic configuration
Run-time configuration change without service interruption
Remote diagnostic functions (need NMS adaptor)
1.TR-69 (DSL Forum) CPE WAN Management Protocol compliant
2.SNR & PE measurements per client
Management
Remote FW upgrade (need NMS adaptor)
Rate Limiting
Set available bandwidth to each subscribers based on pre-determined rule
